Software tools
GS Provisioning tool
Needed for provisioning detectors with item no. 10156 "GS01 Serial Adapter" (USB to battery pack connector). Note: Requires Virtual COM port (VCP) driver from FTDI and Microsoft .NET Framework 4.5.2 (see Drivers section). Compatible with the following MS operating systems (32 and 64-bit): Windows Vista Service Pack 1, Windows 7, Windows 8, Windows 10.
The GS01 Configurator software requires Microsoft .NET Framework 4.5.2. If it does not install automatically, see Drivers section for an offline installer.
In case of problems with YPIF file generation please check that Microsoft Visual C++ 2008 Redistributable is installed on the PC. If installation is required, please find below a link for download.
-
GS01 Configurator
zip, 3.0 MB
(Version 5.1 for detectors with firmware version 3.0 and later)
Important Note: Please use 7-Zip available at http://www.7-zip.org/ to extract the above file or run the setup file in the zip file (no extraction)! -
GS Provisioning Tool v1.9
zip, 20.4 MB
(only for GS01 detectors with old firmware versions 2.1.x.x)
Please contact GasSecure if you are in doubt about the firmware version of your GS01 detector.
GS Viewer
-
GS Viewer 5.2.1.10
zip, 3.2 MB
GasSecure designed the GS Viewer for the following main purposes:
- Visualize GS01 process values (i.e. gas reading) and diagnostic data by connecting a PC to the gateway with Ethernet cable.
- Retrieve GS01 instrument internal data by connecting a PC to the gateway with Ethernet cable and saving these data to file (Excel csv format).
- Simulate diagnostic (warning and error) conditions.
Note that the GS Viewer will only work with Yokogawa gateways and GS01 detectors running firmware (FW) version 3.0 and later. Feature b) requires FW version 3.1 and later.